sw1(config)#link-aggregation 1
sw1(config-link-aggregation1)#?
    arp                   Command arp
    arp-check             Arp-check
    clear                 Command clear
    description           Link Aggregation interface description Information
    dhcp-snooping         Dhcp-snooping
    dot1x                 Configure dot1x parameters
    end                   Exit from configuration mode
    exit                  Exit from current EXEC mode
    frame-tag             Frame tag
    groupping             Send echo messages
    help                  Description of the interactive help system
    inner-priority-trust  Inner tag priority trust
    ip                    Internet protocol configure command
    ip-subnet-vlan        Configure ip subnet vlan attributes
    link-aggregation      Configure Link Aggregation properties
    lldp                  Lldp
    load-interval         Set load interval delay
    logging               Logging
    loopback-detection    Loopback detection
    mac                   Bind a filter based MAC address
    mac-address           MAC address learning
    mac-vlan              Configure mac vlan attributes
    map-table             QoS mapping table
    mvst                  Mvst
    ndsp                  Ndsp
    no                    Command no
    ping                  Send echo messages
    port-security         Security related command
    port-type             Configure interface uni or nni
    protocol-vlan         Configure  protocol vlan
    qos                   Command qos
    rapid-scan            Rapid link scan
    show                  Command show
    shutdown              Shutdown this interface
    spanning-tree         Spanning-tree configuration
    switchport            Configure one or more ports parameters
    traceroute            Trace route to destination
    ulpp                  UpLink Protect Protocol enable
    uni-isolate           Uni interface isolate
    vlan                  Configure vlan
            
sw1(config-link-aggregation1)#

顺便提一下，是迈普，不是思科，我只有两台迈普交换机、没有华三、华为、思科交换机，哪些资料都没有用
【 在 leelou 的大作中提到: 】
: 没做过思科的聚合组， link-aggregation 1之后直接回车呢，是不是到了另一个界面里？
:
--
FROM 117.136.38.*

感谢，链路聚合通了。碰到了新的问题：带宽没有增加，是哪里配的不对？

【 在 leelou 的大作中提到: 】
: 这下面不是有switchport可以配置的吗
:
--
FROM 117.136.38.*